www.janitza.com
9
800-CON Modules
WARNING
Risk of injury due to electrical current and voltage!
Severe bodily injury or death can result! Therefore
please abide by the following:
·
Do not touch bare, stripped wires or device in-
puts that are dangerous to touch on the devic-
es, components and modules.
·
Switch off your installation before commenc-
ing work! Secure it against being switched on!
Check to be sure it is de-energized! Ground and
short circuit! Cover or block off adjacent live
parts!
·
During operation and troubleshooting (especial-
ly with DIN rail devices), check the environment
for dangerous voltages and switch these off if
necessary!
·
Wear protective clothing and protective equip-
ment in accordance with applicable guidelines
when working on electrical systems!
·
Before making connections, ground the device
/ component / module by means of the ground
wire connection, if present!
·
Do not touching bare or stripped leads that are
energized! Equip stranded conductors with wire
ferrules!
·
Hazardous voltages can be present in all cir-
cuitry parts that are connected to the power
supply.
·
Protect wires, cables and devices with a suit-
able line circuit breaker/fuse!
·
Never switch off, remove or tamper with safety
devices!
·
There can still be hazardous voltages present in
the device or in the component (module) even
after it has been disconnected from the supply
voltage (capacitor storage).
·
Do not operate equipment with current trans-
former circuits when open.
·
Only connect screw terminals with the same
number of poles and design!
·
Do not exceed the limit values specified in the
user manual and on the rating plate! This must
also be observed during testing and commis-
sioning.
·
Take note of the safety and warning notices
in the usage information that belongs to the
device, components or modules!
2.4 Hazards when handling the device, compo-
nents and modules
When operating electric devices, components or
modules, it is unavoidable for certain parts of these
devices to conduct hazardous voltage. Consequent-
ly, severe bodily injury or material damage can occur
if they are not handled properly.
Therefore, when handling our devices, components,
or modules, always observe the following:
·do not exceed the limit values specified in the user
manual and on the rating plate! This must also be
observed during testing and commissioning!
·Take note of the safety and warning notices in all
usage information that belongs to the device, com-
ponents or modules!
WARNING
Disregarding the connection conditions of the
Janitza measurement devices, modules or com-
ponents can lead to injuries or even death or to
material damage!
·Do not use Janitza meters, modules or compo-
nents for critical switching, control or protection
applications where the safety of persons and
property depends on this function.
·Do not carry out switching operations with the
Janitza measurement devices, modules or com-
ponents without prior inspection by your system
manager with specialist knowledge! In particular,
the safety of persons, material assets and the ap-
plicable standards must be taken into account!
