800-CON Modules
www.janitza.com
16
2. If this has not yet been done, plug the bus con-
nector (JanBus interface) included in delivery into
the sockets on the rear of your module.
Bus connector
4. Mounting
CAUTION
Disregard of the installation instructions may
cause property damage or personal injury!
Disregard of the assembly instructions may cause
damage to your basic device with module or destroy
it and/or may also result in personal injury.
·
In addition to the installation instructions for
your module, also observe the installation
instructions for your basic device, in particular
the safety and warning information.
·
Before installing modules
-
Disconnect the supply of power to the system!
-
Secure it against being switched on!
-
Check to be sure it is de-energized!
-
Ground and short circuit!
-
Cover or block off adjacent live parts!
·
Provide adequate air circulation in your installa-
tion environment and cooling, as needed, when
the ambient temperatures are high.
·
Return defective modules to Janitza electronics
GmbH in accordance with the shipping in-
structions for air or road freight (complete with
accessories).
·
All usage information is also available as a
download at www.janitza.com.
4.1 Mounting of the UMG 800-CON
Observe the mounting instructions of your basic
device (e.g. check bus connector installation!) and
mount the 800-CON module (transfer module) in the
de-energized system as follows:
1. Press in the bottom bolts on the rear of the
module.
INFORMATION
·The following module assembly sequence must
be observed!
·Always mount the components of your JanBus
system starting from the output bus connector to
the input bus connector. This will avoid an incor-
rect connection of remote JanBus systems! Cf.
Sect. “5.1 Data transfer with 800-CON module” on
ATTENTION
Improper handling may cause damage to the
module and result in material damage!
The contacts of the bus connectors (Janbus interface)
can bend or break off and destroy the bus connector.
·
Never touch or manipulate the contacts of the
bus connector!
·
Never force the bus connector into the module!
·
When handling, transporting and storing the
module, protect the contacts of the bus con-
nector!
Fig.: Module rear view