Jandy
®
Infinite WaterColors
™
Nicheless LED Light | Owner’s Manual
Jandy
®
Infinite WaterColors
™
Nicheless LED Light | Owner’s Manual
ENGLISH
Page 9
2. Snake the electric cord through the conduit outlet of the wall fitting,
into the conduit and up to the location of the pool transformer. Cut the
cord 18”-24” beyond the length needed to reach the transformer to
allow for a service loop. Pull the fixture snug to the wall fitting.
3. Remove protective cover after construction (including plastering for
gunite pools) is complete. Do not plaster the pool with the construction
cover removed.
4. Install cosmetic cover if desired.
5. Apply teflon silicone lube to threads to assist with threading.
NOTE:
When using a 1 1/2” MIP fitting on the back of a SP-1022 or
SP-1408 Wall Fitting, the interior of the Spears and Dura MIP are too small
for use with the Jandy
®
Infinite WaterColors Nicheless LED Lights.
6. Using the included installation tool,
thread the light into the wall fitting
until it is snug. The light face must
be completely flush with the return
fitting. Please provide the pool
owner with a minimum of 1 key
upon job completion.
NOTE: Service
Loop not applicable
for Junction Box
Installations.
Vertical Installation
Infinite WaterColors LED Light Controller,
see table 3.2 for more details
The light face must be completely
snug with the light fitting without
any protrusion from the light fixture.
Conduit to 14VAC Magnetic Transformer
14VAC Magnetic Transformer
The light must be installed with the
light face completely snug with the
light fitting, without any protrusion
from the light fixture, and in
accordance with applicable local
codes and AHJ (Authority Having
Jurisdiction) requirements.
Figure 3.
Standard installation with 1.5” pool wall fitting