Jandy
®
Infinite WaterColors
™
Nicheless LED Light | Owner’s Manual
Jandy
®
Infinite WaterColors
™
Nicheless LED Light | Owner’s Manual
ENGLISH
Page 11
WARNING
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION,
which could result in serious injury or death.
The Jandy Infinite
WaterColors Nicheless LED Lights are only available for 14-volt
AC power. For supply connection, use only the Jandy Infinite
WaterColors LED Light Controller which is an isolating low voltage
power supply with ungrounded output, evaluated and listed by a
Nationally Recognized Testing Laboratory (NRTL) intended for use
with submersible luminaires for swimming pool use.
The Jandy Infinite WaterColors Nicheless LED Lights must be controlled
by the Infinite WaterColors LED Light Controller and AquaLink RS
(revision Y or later) automation system.
Refer to Figure 4 for wiring the Infinite WaterColors LED Lights to
the LED Light Controller. Refer to the Infinite WaterColors LED Light
Controller manual for connecting to the AquaLink RS automation system.
1. Knock out an opening in the right compartment.
2. Run low voltage light through a conduit connector and secure to the
enclosure
3. Connect the low voltage wires black to orange and white to orange, see
Figure 4.
4.2 Wire Gauge and Length
CAUTION
Jandy
®
Nicheless Underwater LED Lights are low voltage fixtures.
Improper wire gauge and wire length can effect the performance of these
products. Follow the guidelines below to determine the proper operation
and optimum performance of the lights.
The output voltage of the Infinite WaterColors LED Light Controller
is 14 VAC to accommodate the voltage drop across cords up to 200 ft.
Installations should not exceed 200 ft.
NOTE:
Each color mode has a slightly different power draw.
4.3 Fourteen (14) Volt Installation
The Infinite WaterColors LED Light Controller IS required to power
Infinite WaterColors Lights.
