Page 11
5. Using two of the four front cover screws, attach the cover to the chassis backplate. Please note that the
chassis backplate has side mounting holes on both sides that allow you to secure the cover to either side
of the backplate while you make all wire connections (see Figure 7).
3.3 Installing APURE700 and APURE1400 Control Center
1. Locate the control center as close to the pump and
fi
ltration system as possible. Make sure that the DC
power cord and the Flow/Temp/Salinity Sensor cable can reach that section of pipe selected for the Cell
and Flow/Temp/Salinity Sensor installation.
Do not install the Control Center within 10 ft (3 m) of the
pool edges.
2. Use hardware provided and mount the control center at eye level. Leave suf
fi
cient clearance on all
sides of the chassis backplate. If possible, leave a minimum of 9½ inch (241 mm) on the left side.
Position the backplate on the mounting surface. Mark screw centers and drill four ¼ inch (6.35 mm)
holes spaced 10
3
/
8
inches (264 mm) on the horizontal center and 6
3
/
8
inches (162 mm) on the vertical
center. Install the anchors (provided) into the mounting surface. See Figure 6.
3. Install the screws (provided) into the anchors, leaving approximately ¼” of the screw shaft exposed.
Position the backplate keyhole slots over the four mounting screws. Press the control center chassis
down
fi
rmly so that the screws are secure in the keyhole slots. Tighten the screws until snug.
4. Remove the four screws that secure the control center front cover. Remove the front cover.
Figure 6.
Mounting the Control Center Chassis Backplate
Drill two (2) holes
spaced 6
3
/
8
” on the
vertical center.
Drill two (2) holes spaced 10
3
/
8
” on
the horizontal center.
Install Anchors (4)
and Screws (4) into
mounting surface
Lower Chassis Keyhole on
to screws and tighten.
Mounting holes
for front cover.
Front cover secured to
available mounting holes.
Figure 7.
Securing the Control Center Front Cover to the Chassis Backplate
Summary of Contents for AquaPure APURE700
Page 2: ......
