6
1. Bolt on the back frame to the right leg (JM0058704) and left leg (JM0058706) of the frame with (14) 3/4” x
2-1/2” bolts and (14) 3/4” centerlock hex nuts.
2. Bolt on axle (JM0058314) with (8) 1” x 3” bolts and (8) 1” centerlock hex nuts.
3. Set the frame up on blocks. Use a tape measure to ensure the back corner of the applicator frame is
approximately 30” off the ground.
5016
5010
Frame
4. Mount tongue (JM0058707) to the right and left leg
frames with (20) 3/4”-10 x 2-1/2” Gr5 Z Hex Bolt and
(20) 3/4”-10 Gr2 Z Centerlock Hex Nut.
5. Mount hydraulic valve block with (4) 1/4” x 2-1/2”
bolts and (4) 1/4” serrated flange hex nut.
6. Connect hoses into valve bank and route them
through the D-ring. The image below is showing the
part numbers of the hoses that connect to each
fitting on the valve bank.
JM0041613
JM0041613
JM0041613
JM0041615
JM0041615
JM0041612
