In this mode, you can check the readout area when using the Multi ROI function. The area
that is not read out is displayed with the brightness reduced to half.
This makes it possible to set and adjust the readout area while checking the target area
on the screen.
Overlay mode
JAI
■
OverlayMode = MultiRoiArea
Image Format
Control
To enable this function, set it in [OverlayMode] of [Image Format Control].
When [Overlay Mode] is set to MultRoiAreaMode, the non-target area is displayed with
half the brightness as shown below.
To set [Overlay Mode] to [MultiRoi Area], [MultiRoi Mode] must be set to Off in advance.
In this mode, if [Overlay Mode] is set to AWBAreaMode and ALCAreaMode, you can check
the photometry areas of WhiteBalance and ALC. In the non-target area as shown below,
the brightness is displayed at half.
HighLeft
HighMidLeft
HighMidRight
HighRight
MidHighLeft
MidHighMidLeft
MidHighMidRight
MidHighRight
MidLowLeft
MidLowMidLeft
MidLowMidRight
MidLowRight
LowLeft
LowMidLeft
LowMidRight
LowRight
■
OverlayMode = AWBAreaMode or ALCAreaMode
Caution
SP-45001M-CXP2A/SP-45001C-CXP2A
- 46 -
