Setting range
Default value
Description
0(fixed)
0
Selects the stream channel to control.
GevSCPHostPort
0
0
Controls the port to which the device must send messages. Setting this
value to 0 closes the message channel.
GevSCPSFireTestPacket
True, False
False
Sends a test packet. When this feature is set, the device will fire one test
packet.
GevSCPSDoNotFragment
True, False
False
The state of this feature is copied into the "do not fragment" bit of IP header
of each stream packet. It can be used by the application to prevent IP
fragmentation of packets on the stream channel.
GevSCPSPacketSize
1476〜16366
ー
This GigE Vision specific feature corresponds to
DeviceStreamChannelPacketSize and should be kept in sync with it. It
specifies the stream packet size, in bytes, to send on the selected channel
for a GVSP transmitter or specifies the maximum packet size supported by a
GVSP receiver.
GevSCPD
0〜4294967295
0
Controls the delay (in GEV timestamp counter unit) to insert between each
packet for this stream channel. This can be used as a crude flow-control
mechanism if the application or the network infrastructure cannot keep up
with the packets coming from the device.
GevSCDA
ー
ー
Controls the destination IP address of the selected stream channel to which
a GVSP transmitter must send data stream or the destination IP address
from which a GVSP receiver may receive data stream.
GevSCSP
ー
ー
Indicates the source port of the stream channel.
Setting range
Default value
Description
Configure image format settings.
2064
2064
Display the maximum image width.
1544
1544
Display the maximum image height.
10: Ten,
12: Twelve
Ten
It shows how many bits the sensor is operating.
2064
2064
Display the maximum image width.
1544
1544
Display the maximum image height.
16〜2064 step 16
2064
Set the image width.
8〜1544 step 4
1544
Set the image height.
0〜2064 step 16
0
Set the horizontal offset.
0〜1544 step 4
0
Set the vertical offset.
Average, Sum
Sum
Set the mode for horizontal binning.
1,2
1
Set the number of pixels in the horizontal direction for which to perform
binning.
Sum
Sum
Set the mode for vertical binning. (Sum fixed)
1,2
1
Set the number of pixels in the vertical direction for which to perform
binning.
RGB8,
RGB10V1Packed,
RGB10p32,
RGB12V1Packed
RGB8
Set the pixel format.
*) RGB12V1Packed can be set only when [VideoProcessBypassMode] is set to [On].
ー
Off
Select the test image.
[Setting range]
0:Off
1:GreyHorizontalRamp
2:GreyVerticalRamp
3:GreyHorizontalRampMoving
4:HorizontalColorBar
5:VerticalColorBar
6:HorizontalColorBarMoving
TestPattern
SensorDigitizationBits
SensorWidth
SensorHeight
PixelFormat
HeightMax
Width
BinningVertical
BinningVerticalMode
OffsetY
Height
ImageFormatControl
WidthMax
BinningHorizontal
BinningHorizontalMode
OffsetX
GevStreamChannelSelector
Item
Item
—
5
7
—
AP-3200T-10GE