JAI AP-3200T-10GE, User Manual, Page: 20 / 75

— 20 —
This section explains how to change settings by describing the procedure for changing
the output format as an example.
Set the output format
Set the size, position, and pixel format of the image to be captured.
The factory default settings are as follows. Change the settings as needed.
The factory default settings (Sensor 0/Stream 0)
Item Default
ImageFormatControl
Width 2064
Height 1544
OffsetX 0
OffsetY 0
PixelFormat RGB8
1
The following example shows how to change the [ImageFormatControl]
-> [Width] setting.
If you select the [Width] item, you can change the value as shown below.
Note
Depending on the setting items, you need to change the visibility.
If necessary, switch between Visibility (Beginner / Expert / Guru).
Step 5 Configuring Basic Settings for the Camera
AP-3200T-10GE
DeviceControl
DeviceVendorName JAI Corporation
DeviceModelName AP-300T-10GE
DeviceManufactureInfo See the possibilities
DeviceVersion XXXXX
DeviceFirmwareVersion XXXXX
DeviceFpgaVersion XXXXX
DeviceSerialNumber XXXXX
DeviceUserID JAI_DEMO
DeviceTemperature XXXXX
DeviceReset ー
ImageFormatControl
SensorWidth 2064
SensorHeight 1544
SensorDigitizationTaps Twelve
WidthMax 2064
HeightMax 1544
Width 2064
Height 1544
Offset X 0
Offset Y 0
×
Device Control
Beginner Visibility