32
JAGA N.V. | DBH SET - BMS | MANUEL | 2021.08.23 | V.01
4. SETTINGS VIA CIRCUIT BOARD CONTROLLER
4.1. ADJUSTING THE WATER TEMPERATURE
4.1.1. Adjusting the maximum water temperature for cooling
By reducing the water temperature setting, the unit will start later. If the water temperature is set
higher, the unit will start sooner .
1. Start setup mode: press and hold the [
-
] button until the blue LED flashes 5x and release .
2. Short press the [-] or [+] button to adjust the set temperature .
3.
Exit setup mode: hold the [-] button until the
blue LED
flashes 5x and release .
4.1.2. Adjusting the minimum water temperature for heating
By increasing the water temperature setting, the unit will start later. If the water temperature is set
lower, the unit will start sooner .
In combination with a heat pump, it may be necessary to reduce the water temperature .
1. Start setup mode: Press and hold the [
+
] button until the red LED flashes 5x and release .
2. Short press the [-] or [+] button to adjust the set temperature .
12 ̊C
14 ̊C
16 ̊C
18 ̊C
20 ̊C
22 ̊C
24 ̊C
26 ̊C
The blue LED flashes quickly when the minimum temperature is reached.
.
The blue LED flashes quickly when the minimum temperature is reached.
.
The red LED flashes quickly
when the maximum temperature is reached. .
The red LED flashes quickly
when the maximum temperature is reached. .
Automatic control: The green LED lights up when the water temperature (supply water) is lower
than the set temperature
Automatic control: The green LED lights when the water temperature (supply water) exceeds the
set temperature .
24 ̊C
26 ̊C
28 ̊C
30 ̊C
32 ̊C
34 ̊C
36 ̊C
38 ̊C
3. Exit setup mode: press and hold the [
+
] button until the red LED flashes 5x and release .
After 30 seconds, the new settings are automatically saved and the device returns to the
selected mode. .
-
-
-
-
