H 9 6 5 2 1 6 C
3/4" Thermostatic Mixing
Valve Trim Kit
CHECK STOP
(RED TO BLUE)
CHECK STOP
(BLUE TO RED)
PIN
Should the hot and cold water supply pipes have been
transposed making adjustment impossible, proceed as
follows:
Important note: RED CHECK STOP is now on the right of the
mixer body and the BLUE CHECK STOP is now on the left.
TRANSPOSED SUPPLY PIPING
4
OPERATING THE VALVE
5
Remove check stops and re-install them transposed.
Shut off water supply.
Remove handle and rim
Turn the water supply back on and perform the temperature
adjustment in step 1.
If a temperature over 100
°
F is desired, push the STOP
BUTTON
(1)
down and turn the TEMPERATURE KNOB
(2)
.
This will increase the mixed water temperature up to the
maximum limit previously selected in step 1.
2
1
100
3
HANDLE INSTALLATION
Push TEMPERATURE-CONTROL KNOB
(1)
onto KNOB
MOUNT
(2)
. Attach TEMPERATURE-CONTROL KNOB
(1)
to valve with ATTACHMENT SCREW
(3)
. Push
HANDLE BASE
(4)
onto TEMPERATURE-CONTROL
KNOB
(1)
. Tighten set screw with HEX WRENCH
(5)
to secure HANDLE BASE
(4)
.
Remove TEMPERATURE CONTROL KNOB
(1)
from
HANDLE BASE
(4)
by loosening SET SCREW with
HEX WRENCH
(5)
.
For 818 Series Cross Handle
: Align Pin on CROSS HANDLE
(6)
with hole in
HANDLE BASE
(4)
. Tighten SCREW
(7)
. Insert INDEX
(8)
into CROSS HANDLE
(6)
.
For 888 Series Cross Handle
: Align Pin on CROSS HANDLE
(9)
with hole in
HANDLE BASE
(4)
. Tighten SET SCREW with HEX WRENCH
(10)
supplied.
100
2
1
3
4
6 7 8
9
5
10
2
1
2
Push CAP
(1)
over the O-RING SEAL
(2)
.
TRIM INSTALLATION
3
4
5
Push ESCUTCHEON
(3)
over CAP
(1)
and secure
with SCREWS
(4)
.
Slide COVER PLATE
(5)
onto CAP
(1)
flush against ESCUTCHEON
(3)
.