H 9 6 5 2 1 6 C
3/4" Thermostatic Mixing
Valve Trim Kit
Phillips Screwdriver
RECOMMENDED TOOLS
Regular Screwdriver
TEMPERATURE CALIBRATION
1
Unscrew PLASTER GUARD SCREWS and remove PLASTER GUARD.
Check that arrow marking B points vertically upwards. If not, push
the BLACK CLAMP on the SECURING RING to the right, pull off KNOB
MOUNT and reinstall KNOB MOUNT with arrow "B" pointing upwards.
For 100
°
F adjustment, turn the water supply on. Turn KNOB
MOUNT until the spout temperature is 100
°
F. Check that arrow
marking A on the KNOB MOUNT still points upward after adjusting
the thermostat to 100
°
F. If not, pull out the RED LOCKING DEVICE.
Remove KNOB MOUNT by pulling it towards you while standing directly
in front of the valve.
Reinstall the KNOB MOUNT so that the arrow marking A points upwards.
The maximum mixed water temperature is set at 109
°
F at the
factory. This setting can be changed if desired.
Remove the TEMPERATURE LIMIT STOP (H shaped Black Plastic
part). Re-install it at the desired notch as indicated in the diagram
to limit the maximum mixed water temperature to 104
°
F or 112
°
F.
Reinstall RED LOCKING DEVICE.
KNOB
MOUNT
ARROW
"A"
BLACK
CLAMP
ARROW
"B"
RED LOCKING
DEVICE
SECURING
RING
104
°
109
°
112
°
TEMPERATURE
LIMIT STOP
ROUGHING-IN DIMENSIONS
FINISHED
FLOOR
FINISHED
WALL
1-11/16"
TO
2-1/2"
(42mm TO
64mm)
3/4" NPT OUTLETS
(19mm)
3/4" NPT INLETS
(19 mm)
5-7/8"
(149mm)
CL
48" TO 54"
FOR SHOWER ONLY
(OPTIONAL)
(1219mm TO 1372mm)
32" TO 42"
FOR BATH/SHOWER
AND BATH FILLER
(OPTIONAL)
(813mm TO 1067mm)
7-3/16"
(182.5mm)
3-3/8"
(86mm)
For reference
