21
WARNING
: TO DECREASE RISK OF INFECTION AND DISEASE.
Fill the swim spa with clean tap water from garden hose, to reduce the risk of con-
trac ng a waterborne illness (e.g. an infec on, bacteria or virus) and/or respiratory ailments.
Fill un l water covers all the jets but does not touch the bo om of the lowest headrest
(DO
NOT OVERFILL!).
IMPORTANT
:
Always fill your swim spa through both filter fi ngs a er draining. Failure to
do so may cause air to be trapped in the pumps, preven ng the pumps from circula ng water.
Remove the hose and replace both filter cartridges as illustrated in Sec on 13.1.
3.
Turn On Power
Turn on the power to the swim spa at the home’s circuit breaker. The heater and filter/
circula on pump will automa cally ac vate. Normally, at the ini al fill, the water tends
to be cold.
4.
Ac vate Jet Pumps
Turn on jet pumps when adding chemicals in step 5 (see sec on 11.2)
5.
Add Start-Up Chemicals
Add the swim spa water chemicals as recommended by your authorized Jacuzzi swim
spa dealer. See sec on tled “Water Quality Maintenance” for general guidance.
WARNING
: RISK OF POISONING OR DEATH.
Never leave chemicals opened and accessible to anyone. Use chemicals according to
the vendor’s instruc ons. Always store chemicals in a safe and/or locked loca on. Keep away
from and out of reach of children.
6.
Establish A Stable Sani zer Reading
Establish a stable sani zer reading of no less than 2.0 ppm free bromine. To ensure
healthy water condi ons, always maintain a constant sani zer reading within the levels
recommended on the inside cover of this manual. If sani zer levels cannot be stabilized,
perform the decontamina on procedure steps 9
-15 on the following pages.
Note:
The “Decontamina on Procedure” should also be used a er the swim spa has been
“Winterized” (Sec on 13.8) or has been si ng without power for an extended period.
