Electrical requirements
Your J-Dream II, as it comes from the factory, requires a GFCI protected 220/240 VAC 15 AMP 3-wire circuit (2 conductor with ground)
for single (1) phase electrical service, and must be in a separate circuit having no other appliance connected in that circuit. If you
do not have this kind of circuit, a qualified electrician should be called in to install the necessary wiring. Inadequately sized wiring or
locating the unit too far from the main service panel may cause a voltage drop. A drop in voltage can cause the unit to malfunction
and bring about permanent damage to the shower's electrical system. The circuit ground wire must be provided to take advantage
of the designed-in safety features of the J-Dream II. Bond according to procedure described on page 23. Caution: Without proper
grounding and bonding, a system malfunction may cause fatal shock.
Electrical precautions
Lighting and electrical receptacles must be located at least 5 ft (1.5m) from the J-Dream II. Lighting located between 5 ft and 10
ft (1.5m and 3m) from the J-Dream II must be on a circuit protected by a GFCI. Do not use electrically connected devices, such as
television, radio, telephones, stereo speakers, lights or cooking devices within 5 feet of the J-Dream II while it is in use.
Ventilation
Water which drips on the floor during exit from the J-Dream II may cause a walking hazard and/or structural damage unless proper
waterproof building materials are used in the area surrounding the unit. Take into consideration, also, the high room humidity which
will exist due to use of the steamer. Providing natural or forced ventilation of the room will help maintain comfort and minimize moisture
damage to the building. Jacuzzi Whirlpool Bath is not responsible for damages resulting from excess moisture or water spillage.
Consult an architect or engineer for aid in designing your installation.
Maintenance
Cleaning the J-Dream II
To clean your J-Dream II, simply use a mild non-abrasive liquid detergent or commercially prepared bathtub cleaners. Do not use
abrasive cleaners. You can protect and restore the gloss to a dulled surface by applying a plastic polish specifically designed for
use on acrylic finishes (methylmethacrylate). If an acrylic polish is not available, an automotive paste wax will do.
Repairs to the surface
Minor scratches which do not penetrate the color finish (acrylic) can be removed with 600-grit wet/dry sandpaper. Restore the glossy
finish with an acrylic polish or a comparable automotive paste wax.
Major scratches or gouges which penetrate the acrylic surface will require refinishing. Ask your dealer for special instructions.
J-Dream II Owner's Manual
4