9
Drain Fitting
(provided with unit)
Leave enough flexibility in the waste line to allow the end of the stub-out to
be blocked temporarily in a position under flush with the floor surface. This
will allow the shower unit to slide across the floor into position without
having to lift the shower unit.
Remove the block and pull the drain assembly up to insert the stub into the drain.
The drain fitting is a non-caulk type (compression fitting) drain. Make certain that the
locking ring is loose to allow the drain stub to insert easily inside the rubber compression
sleeve. If necessary, lubricate the sleeve with a mild soap solution. The drain stub must
extend well into the rubber sleeve before the locking ring is tightened. Use a screwdriver
and the assembly tool provided to tighten the locking ring.
Studwall
Drain
Compression
Fitting
Temporary
Wood Block
Drain Assembly
Floor
Broken Line
Represents
Drain Stub
Assembly Tool
Locking
Ring
Rubber
Compression
Sleeve
Screwdriver
Tighten
Locking Ring
Clockwise
J-Dream II Owner's Manual