Jacuzzi J-ALLURE, Installation And Operation Instructions Manual

Page: 17 / 32

J-Allure
15
Fixed Panels Installation
(cont.)
Install the two wall extrusions on the ends of the fixed panel assembly. Make sure they are flush against each fixed
panel.
Where the fixed panel assembly will rest on the bath rim, apply sealant. Position the fixed panel assembly on the bath
by inserting the pin into its seat on the lower guide. The curve of the fixed panel should match the curve of the bath.
Lift left side wall through the open doors. Insert the 3 bolts (welded on the side wall frame) into the slotted holes in
the center panel frame. Place the opposite side of the side wall against the fixed panel frame. Make sure the wall
extrusion is against the wall. Check perpendicularity with a level. Mark this wall extrusion position. Remove left side
wall and repeat the above steps for the right side wall. Remove this side wall and fixed panels assembly.
Using the 3 holes in each extrusion as a guide, drill three 15/64" holes into adjacent wall for each side. Attach the wall
extrusions to the walls with the anchors and 3.5x32mm screws. Drill three 7/64" holes into the fixed panel frame using
the wall extrusion holes as guides. Secure the panel frame to the wall extrusion with 3.5x9.5mm self-threading screws.
SEALANT
PIN
FIXED PANEL
ASSEMBLY
WALL
EXTRUSION
FIXED PANEL
ASSEMBLY
WALL
EXTRUSION
FIXED
PANEL
FRAME
FRAME OF
CENTER PANEL
SIDE
WALL
MARK