57
“FREEZE PROTECTION”
A potential freeze condition has
been detected. No action is required. Jets pump(s) operate until
the spa is out of danger. No corrective action is necessary.
I
If
condition persists, contact your authorized dealer or service
organization.
“OVERHEAT PROTECTION”
Do not enter the water!
Water temperature is above acceptable limits. Heater is deacti-
vated. Remove spa cover to speed cooling.
I
If condition persists, contact your authorized dealer or serv-
ice organization.
Note: The heater icon (
) will be blinking and the error icon
(
) will be displayed under the temperature.
As an extra safety measure, the hot tub lights flash with a red light.
Risk of Hyperthermia (over-heating) Causing Severe
Injury, burns, or welts.
“WATCHDOG PROTECTION”
DO NOT ENTER SPA!
Water temperature is above acceptable limits. Your spa is deac-
tivated. Remove spa cover to speed cooling.
I
If condition persists, contact your authorized dealer or serv-
ice organization.
Note: The heater icon (
) will be blinking and the error icon
(
) will be displayed under the temperature.
Risk of hyperthermia, burns and scalds.
“WATCHDOG FREEZE PROTECTION”
Spa water is below 40°F/4.4°C. Jet pumps operate until the
spa is out of danger.
I
Contact your authorized dealer or service organization.
Note: The heater icon (
) will be blinking and the error icon
(
) will be displayed under the temperature.
“CONTROLLER OVERHEAT PROTECTION”
Controller temperature has exceeded acceptable limits. If con-
dition persists, provide shade for equipment side of spa.
I
Contact your authorized dealer or service organization.
Note: The heater icon (
) will be blinking and the error icon
(
) will be displayed under the temperature.
“PANEL COM ERROR”
The topside controller is having trouble communicating to your
spa.
I
Contact your authorized dealer or service organization.
“STEREO COM ERROR”
The stereo is having trouble communicating to your spa.
I
Contact your authorized dealer or service organization.
“CLEARRAY REPLACEMENT REMINDER”
This message will appear when the CLEARRAY bulb reminder
time has expired.
I
The CLEARRAY bulb must be replaced.
“PROCLARITY/PROCLEAR FILTER REMINDER”
This message will appear when the filter reminder time has
expired.
I
Remove the ProClarity/Proclear filters and filter/debris bag
for cleaning or replacement.
“PROCLARITY DEPTH FILTER REMINDER”
This message will appear when the filter reminder time has
expired.
I
The ProClarity Depth filter must be replaced.
“WATER REFRESH REMINDER”
This message will appear when the “Water Refresh” timer has
expired.
I
The water needs to be drained and refilled with fresh water.
“EXTENDED TEMPERATURE ACTIVATED”
The spa is set to go up to 40°C (104°F), but it can be set to reach
41°C (106°F). To access the extended temperature you need
press and hold your finger over the temperature reading for
about 5 seconds. The temperature reading will start to blink to
indicate the system is ready. Tap (
)
to raise the tempera-
ture up to 41°C (106°F).
Note:
The heater icon (
) will be blinking to indicate that
the feature is active.
ON
ON
ON
ON
It’s time to replace your CLEARRAY bulb.
Contact your authorized dealer for replace-
ment parts.
Reminder
reset
snooze
It’s time to clean or replace your ProClarity
and ProClear filters. Contact your autho-
rized dealer if new filters are needed.
Reminder
reset
snooze
It’s time to replace your ProClarity Depth
Filter. Contact your authorized dealer for a
new filter.
Reminder
reset
snooze
Your spa needs to be drained and refilled
with fresh water. Refer to your owner’s
manual for draining procedure.
Reminder
reset
snooze
ON
Summary of Contents for J-500 Series
Page 2: ......
Page 3: ...Italiano Avvertenze 4 English Warnings 32 Fran ais Recommandations 59 Index...
Page 90: ...90...
Page 91: ...91...