41/64
5. Troubleshooting
In the event of malfunctioning of the Shears, look for the causes in the following way:
ACOUSTIC SIGNALS
Action
Acoustic signal
State of the tool
Startup
Press the button (3) for 1 second
3 beeps
Battery on (device still not recognised)
1 beep
Battery on (device recognised)
Opening operation
Cutting trigger (1) pressed for 3
seconds
1 short beep
Blade opening (Shears ready for use)
Cutting cycle
Cutting trigger (1) p button
(3) for 0.5 seconds with blade
closed)
1 beep
Blade opening change
Close stop
Cutting trigger (1) pressed twice in
quick succession, then held down
with the blades closed
1 beep
Shears in standby (blades closed position)
Warning
During the work
1 beep
Excessive strain (b par. 3.8)
4 beeps
Alarm (c par. 3.8)
Charging *
Connect to the battery charger
3 beeps
Shears disabled
Auto power off
-
3 beeps
Off
INCIDENT DIAGNOSIS
Problem
Cause
Possible solution **
The battery does not turn on
The battery is low
Re-charge
The Shears have stopped in work
Overexertion (stop in cutting) (“a”, “b”, “c”
paragraph 3.8)
The Shears have an overdue is in limit to protect the
equipment. In the case of overexertion, the Shears stop
automatically. Perform less heavy-duty cutting cycles.
The Shears do not work
The Shears are not properly connected
to the battery
Make sure the Shears are properly connected to the battery
The battery charge is very low
Make sure the batteries are charged
The device connection cable is faulty
Replace the connection cable
Hardware fault
Contact the Service Centre
The Shears have little cutting power
or cut badly
The cutting blade is very worn or
notched
Keep the blade sharpened at all times
The counter blade is highly worn
Check and change if necessary
The Shears heat up excessively
The cutting blade is highly worn or
notched
Check and change if necessary or sharpen
The counter blade is highly worn
Check and change if necessary or sharpen
The battery does not last long
Kept the cutting blade is highly worn
or notched
Keep the blade well sharpened at all times
The counter blade is highly worn
Check and change if necessary or sharpen
The charger does not work
Check the state of the charger.
*For proper safety, charge the battery only with the device disconnected.
** lf the problem is not solved, you must go to your distributor and/or nearest Authorized Technical Service.
Summary of Contents for PR-40
Page 21: ...21 64...