21/43
Screws
Hose
Hose clamp
Joystick
Duct
L-shaped slot
Pin
Support duct
Extender duct
Joystick
cable
cover
Screws
Joystick
•
Repeat the same procedure to fit the extender ducts into the support duct;
•
After assembling the ducts, fit the joystick and screw it;
•
Finally, fit the duct into the hose, and secure it with the clamp.
To assemble the power cables on the joystick, follow the steps below:
•
Remove the joystick cable cover, and turn on the connectors;
•
The 180° connectors belong to the battery cable and must be connected to
the cable harness connectors located on the joystick left side. Same color ca-
bles must be connected to same color cables;
Doser cable
90º connector
Metal terminals
Battery cable
180º connector
Cable harness
connector
•
The 90° connectors belong to the doser cable and must be connected to the
board metal terminals on the joystick right side. Each connector has the speci-
fic size of the terminal where it must be connected;
•
Before closing the joystick cable cover, position the cables so they are not
strangled or tensioned, and damaged;
•
To close the cover, position the cable protector as shown in the image below;
Joystick
cable
cover
Cable
protector
Screws
Wider
profile
•
It is important to notice that on the inside of the cable protector, the wider
profile should be positioned downwards, in contact with the bottom of the
fitting. Otherwise, the cover will not fit properly;
