![background image](http://html1.mh-extra.com/html/jacobsen/hr800/hr800_safety-operation-and-maintenance-manual_3662416046.webp)
4 CONTROLS
en-45
4.2.23.54 WARNING SLOPE ANGLE - INHIBIT CUT___________________________________
If the slope angle reaches 21° the screen will display this warning indicating that
at 21° the front cutter deck will be lifted and held above the ground to improve the
stability and all cutting units will stop rotation. An audible warning will be given, the
buzzer will sound four times every 4 seconds and the red LED’s will flash four
times every 4 seconds. This will continue until the machine has been driven to an
area with a slope of less than 19°.
Press the button below the
to confirm the fault.
4.2.23.55 WARNING OIL-PRESSURE FAULT ________________________________________
When this screen is shown, the engine oil pressure has decreased below the
normal level. If this happens during operation, Stop the engine and check the oil
level. Top up if necessary. If the problem persists consult your service dealer.
Press the button below the
to confirm the fault.
4.2.23.56 WARNING CLEAR RADIATOR SCREENS __________________________________
When this screen is shown, the engine temperature has risen above the normal
levels.
Park the machine in a safe area disengage cutting units, set engine to idle to allow
engine temperature to decrease prior to switching off the engine.
Clean the radiator and screens of all grass and debris.
Press the button below the
to confirm the fault.
NOTICE
The number in the top right of the screen indicates the total number of current faults recorded. If more than one fault,
it will cycle all current faults.
1
0°
Slopes > = 21°
in either x or y
!
OIL PRESSURE
FAULT
1
!
CLEAR BUG
SCREEN
1