Jacobsen Greens King IV 62302, Operation Manual

Page: 10 / 26

3 SET-UP
10
3.7 STEERING WHEEL ________________________________________________________
1. Remove hex jam nut (R) from steering column.
2. Position the steering wheel over the shaft then
reassemble the hex jam nut. Torque nut to 25-30 ft.
lb. (34-41Nm) and install the steering wheel cap
(S) .
Figure 3E
3.8 ROPS ___________________________________________________________________
The ROPS mounting bracket (Y) has been assembled to
the mower at the factory, but is shown unassembled for
clarity.
1. Fully lower mowers to the ground.
2. Remove hardware (T) from one side of the ROPS.
Separate the ROPS into left (W) and right (X)
halves.
3. Remove hardware (AB) securing rear lift cylinder to
lift arm.
NOTE: Leave ROPS hardware (T, U and V) loose until
ROPS is completely installed, then tighten hardware.
4. Slide the ROPS halves into the mounting bracket
(Y) . Secure with 1/2-13 x 2-3/4” socket head screws,
high collar lockwashers (U) , and spacers (AA) .
NOTE: Rear lift cylinder needs to be pivoted towards the
left side of the machine to insert the left side bolt.
5. Secure tube plates to bracket with 3/8-16 x 1”
screws and lockwashers
(V) .
6. Secure top portion of two halves of ROPS tubes
with hardware
(T) .
7. Torque hardware (U) to 75 ft. lb. (101.7 Nm).
Torque hardware (T and V) to 30 ft. lb. (40.7 Nm).
8. Assemble lift cylinder to lift arm with hardware (AB) .
Torque hardware to 75 ft. lb. (101.7 Nm).
Figure 3F
R
S
Y
AA
AA
X
W
T
U
U
V
V
AB
AB