Jacobsen AR3, Technical/Repair Manual

Page: 260 / 342

STEERING
4181384 First Edition 7-11
7
Figure 7-12
NOTE
Record the location of the fittings before removal to
ensure correct installation.
9. Remove fittings (23 and 24) from the steering
cylinder (15).
10. Inspect O-rings on fittings (23 and 24). Replace as
needed.
11. Remove the rod end (21) and jam nut (20) from the
steering cylinder (15).
12. Bend the tab washers (19) away from the screws (18)
and remove the screws.
13. Remove the journal (22) from the steering cylinder
(15).
14. Inspect bushings (16 and 17). Replace as needed.
Installation Notes
• Install the steering cylinder by reversing the order of
removal.
Figure 7-13
• Install (tighten) screw (25) fully into the rear wheel
support (28) before installing the nut (27).
• Tighten nut (27) to 103 lb-ft (140 N·m).
• Apply grease to lubrication fitting (26). (Refer to
“Safety, Operation, and Maintenance Manual” for
grease specifications.)
• Check hydraulic oil level. Add oil as needed. (Refer to
“Safety, Operation, and Maintenance Manual” for
hydraulic oil specifications.)
Disassembly and Assembly
See Figures 7-14 through 7-19.
Figure 7-14
1. Remove (unscrew) the end cap (1) from the cylinder
body (2).
15
TN1218
16
18
21
20
23
16
24
17
19
22
17
19
18
TN1216
27
25
26
28
TN1251
1
2