background image

18

n. 

WArrAnty AnD serVices

Warranty

The warranty is the only warranty applicable to this product. All other warranties, express 
or implied (including all implied warranties of merchantability or fitness for a particular 
purpose) are hereby disclaimed. No verbal or written information given by Bell Xpress A/S., 
its agents, or employees shall create a guaranty or in any way increase the scope of this 
warranty.
Repair or replacement as provided under this warranty is the exclusive remedy of the 
consumer. Bell Xpress A/S shall not be liable for incidental or consequential damages 
resulting from the use of this product or arising out of any breach of any express or implied 
warranty on this product. Except to the extent prohibited by applicable law, any implied 
warranty of merchantability or fitness for a particular purpose on this product is limited to 
the applicable warranty period of 1 months.

-  The contents of this manual are subject to change without notice.

service center

Improvee Corporation
589 Ne Elam Young Parkway Ste G00
Hillsboro, OR 9714
Email: [email protected]
Toll-Free phone: 888 880 8090

 

o. 

fcc compliAnce

Your telephone equipment is approved for connection to the public switched telephone 
network and is in compliance with parts 15 and 68, FCC Rules and Regulations and the 
Technical Requirements for Telephone Terminal Equipment published by ACTA.

united states fcc compliance 

This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment 
generates uses and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. 
If this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit difference from that to which the 
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications to the equipment not expressly approved by the party 
responsible for compliance could void the user’s authority to operate the equipment.
The information shown in FCC Declaration of Conformity paragraph below is a requirement 
of the FCC and is intended to supply you with information regarded the FCC approval of 
this device. The phone numbers listed are FCC-related questions only and not intended for 
questions regarding the connection or operation for this device, Please contact your cable 
service provider for any questions you may have regarding the operation or installation of 
this device.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 
two conditions: (1) this device may not cause harmful interference, and () this device must 
accept any interference received, including interference that may cause undesired operation.  
Privacy of communications may not be ensured when using this phone.

  

fcc Declaration of conformity

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 
two conditions: (1) this device may not cause harmful interference, and () this device must 
accept any interference received, including interference that may cause undesired operation. 
Privacy of communications may not be ensured when using this phone.

Hearing Aid compatibility (HAc)

This equipment is hearing aid compatible as defined in FCC CFR 47 Section 68.316. 
Important! Assure that all telephones and phone lines used with this equipment have been 
disconnected from the public telecommunications networks.

fcc rf radiation exposure statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled 
environment. This equipment should be installed and operated with a minimum distance of 
0 cm between radiator and your body. This transmitter must not be co-located or operating 
in conjunction with any other antenna or transmitter.
For hand held operation, this phone has been tested and meets the FCC RF exposure 
guidelines. Use of other accessories may not ensure compliance with FCC RF exposure 
guidelines.



Summary of Contents for 80





















Reviews: