15
MAIN BURNER LIGHTING
BEFORE LIGHTING:
Carefully inspect the
gas supply hose before turning the gas “ON”. If there is evidence of cuts, wear, or
abrasion, it must be replaced before use, the replacement hose assembly shall be that specified by the
manufacturer.
VERY IMPORTANT: ALWAYS INSPECT THE HOSE BEFORE EACH USE OF THIS GRILL.
TO LIGHT MAIN BURNERS OF THE GRILL:
1. Read instructions before lighting.
2. Turn all knobs to
“OFF” then open the L.P. tank valve. Always keep your face and body as far from the
grill as possible when lighting.
3. Open lid during lighting.
4. Push and turn any control knob
slowly
to “HI” position. The built-in igniter will click and spark
simultaneously to light the pilot and burner in sequence. Turn the control knob to OFF IMMEDIATELY if
the burner does not light within 5 seconds, wait 5 minutes for gas to dispel, then repeat the lighting
procedure.
5. Follow match lighting instructions if burner can
’t be lit after repeated 3-4 times.
MANUAL BURNER LIGHTING MAIN BURNER
See your local dealer for service if your grill igniter is not functioning.
1. Remove the cooking grates and the flame tamers that are over each burner.
2. Turn the burner you are lighting to high / light and place a long match near the side gas ports of the
burner.
3. If the burner does not immediately light, turn the valve to OFF. Wait 5 minutes then repeat lighting
procedures.
REAR BURNER LIGHTING
When operating the rear burner please ensure that the warming rack is
REMOVED
. The warming rack will
become damaged if
NOT
removed while the rear infrared burner is in use.
The rear burner is specially designed to be used with the rotisserie kit, and should ONLY be used when using
the rotisserie kit.
To light the rear burner:
1. Depress the ignition button and then turn the rear burner control knob to HI.
2. If the burner does not light within 5 seconds, turn control knob to OFF. Wait 5 minutes then repeat
lighting procedures.
