7
Figure 1 Figure 1
Mai n burner
Open ~ 1/8” for Nat Ga
s
Open ~ ¼” for Propane G
as
Figure 2
Tools Required for Assembly:
Please use the proper tools to simplify installation and prevent injury or damage to your grill.
◼
Tool Included with your Grill:
1
x
5mm Allen Wrench (for Casters)
1
x
2mm Allen Wrench (for Knobs)
◼
Installer Supplied Tools:
1
x
Large Phillips Screwdriver
1
x
Medium Phillips Screwdriver
1
x
OPTIONAL: Socket wrench with 6mm Allen driver.
Assembling & Preparing your Grill:
◼
Install Casters (CART ONLY):
1. Install locking casters at the front, and the non-locking casters at the rear of your grill.
2. Using the supplied Allen wrench, install the casters by bolting them into the bottom 4 corners of your grill.
◼
CHECK BURNER FIT on ORIFICES:
1. Inspect burners to ensure that they are all inserted
correctly onto the orifices (AKA the outlet of the valves; Fig 1)
2. If any burner is NOT correctly installed over the valve as shown in Fig 1, remove
the burner retaining clip, remove the burner, and reinstall correctly.
3.
Ensure each air shutter is set ~ 1/8” open for natural gas, or ~ ¼” open for
propane gas (see diagram on page 51). Although we have pre-set the air shutters
on the burners of this product, it may be necessary to adjust them for optimum performance. This is an
outdoor appliance and geography and climate can necessitate an
adjustment to the air shutters. The correct flame characteristics can
be found on page 15 of your owner’s manual.
◼
INSTALL FLAME DIFFUSERS & COOK GRIDS:
1. Remove the flame diffusers, grids & warming rack from the packaging.
2. Install each diffuser directly above each burner by setting them into the slotted
ledges, in the front and rear of the firebox. (Fig. 2)
3. Once the flame diffusers have been installed, set the cooking grids on the upper
ledges of the firebox in the grill, with the grill bars oriented front to rear.
4. Install the warming rack above cook grids, on the 2 brackets located on the left &
right inner walls of the inner hood.
◼
PREPARE REAR BURNER IGNITER:
1. Unscrew the plastic/rubber cap from the rear burner ignition module, and insert
supplied AAA battery with the positive end facing out. (Fig. 3)
2. Re-install cap.
Figure 3
Tip of brass orifice,
on end of valve;
correctly hidden
inside burner.
Summary of Contents for LUX Series
Page 23: ...23 Exploded View LUX JLS700 BUILT IN Model...
Page 26: ...26 Exploded View LUX JLS700 CART Model...
Page 54: ...54 Vue clat e LUX JLS700BI...
Page 57: ...57 Vue clat e LUX JLS700...
