13
/
14
Err-08
Arm shaft motor
stalled
1. Please check whether there is any foreign object wrapped around the machine
head, whether there is any thread residue stuck in the rotating shuttle, and
whether the eccentric wheel of the machine is stuck.
2. Disconnect the power supply of the controller and check whether the input plug
of the arm shaft motor power supply is detached, loose, or damaged.
3. If the system still does not work properly after troubleshooting and
restart.Please contact your local service provider or call 4008876858.
Err-10
Panel communication
failure
1
、
Please check whether the connection between the operation panel and the
electric control is drops off, loose, or broken.
2
、
If the system still does not work properly after troubleshooting and
restart.Please contact your local service provider or call 4008876858.
Err-12
Arm shaft motor initial
angle detection failure
1. Please enter parameter setting to check the initial angle of the arm shaft motor.
2. Please try 2-3 times again after power off. If it still fails.Please contact your
local service provider or call 4008876858.
Err-13
Arm shaft motor zero
position fault
1. Turn off the power of the system, check whether the arm shaft motor encoder
connector is loose, or drops off. Restore it to normal and restart the system.
2. Replace the arm shaft motor encoder.
3. If the system still does not work properly after troubleshooting and restart
，
Please
contact your local service provider or call 4008876858.
Err-14
Master control eeprom
components read/write
failure
Turn off the system power, and then turn on the power again after 30 seconds. If the
controller still does not work properly, please contact your local service provider or
call 4008876858
Err-15
Arm shaft motor
overspeed protection
Err-16
Arm shaft motor
reverse
Err-17
Pandel date read/write
failure
Turn off the system power, and then turn on the power again after 30 seconds. If the
controller still does not work properly, please contact your local service provider or
call 4008876858
Err-18
Arm shaft motor
overload
Check whether the arm shaft motor is stalled. If not, please contact your local
service provider or call 4008876858.
Err-19
Motor type mismatch
Turn off the system power, and then turn on the power again after 30 seconds. If the
controller still does not work properly, please contact your local service provider or
call 4008876858
Err-20
Pedal error
1
、
Please check whether the connection cable of the pedal speed controller is drops
off, loose, or damaged.
2. If the system still does not work properly after troubleshooting and restart.Please
contact your local service provider or call 4008876858.
Err-21
Backstitch step motor
hardware overcurrent
1. Turn off the system power, and then turn on the power again after 30 seconds
2. Check whether the backstitch step motor, swing seat, and teeth are stuck. After
returning to the normal state, restart the system.
3. If the system still does not work properly after troubleshooting and restart. Please
contact your local service provider or call 4008876858
Err-22
Backstitch step motor
software overcurrent
1. Turn off the system power, and then turn on the power again after 30 seconds
2. Check whether the backstitch step motor, swing seat, and teeth are stuck. After
returning to the normal state, restart the system.
3. If the system still does not work properly after troubleshooting and restart. Please
contact your local service provider or call 4008876858
