Press the button and hold on, then press the button to
enter the monitor mode, the parameter display. Press
until the third number is flicking, press again to , angle
initial display. Value 120 is normal, and the error is about 8
degrees. (
: This parameter can only be viewed, not be
adjusted)
Note
Press the button and hold on, then press the button
again, the machine version ill display on the
operation panel
Press the button and hold on, then press the button to
enter the monitor mode, display. Press the button
untill the third number is flicking, then press the button
to . The last four numbers refer software version.
This parameter can only be viewed, not be adjusted)
P
10
11
P
>
Initial angle value check method
Check the machine version
Version check method
Check the software version
P
>
Manual Book of A4
Product Introduction
Summary of Contents for A4
Page 21: ...Notes Notes...
Page 22: ...Notes Notes...
