18
engine.
When running, do not increase or
decrease the vehicle speed abruptly
and do not shake the steering wheel
without reason, listen whether there is
abnormal noise or not, check the
reading and indicator lamp of all the
instruments for normalization. If
finding abnormal noise or abnormal
events, stop the vehicle immediately
and check it, take necessary
adjustment and repair.
When downgrading, do not stall the
engine. When downgrading steep
ramp, shift the shifting rod into low
gear and take braking operation at
intervals to avoid the over speeding
running
When running across a shallow river
or loblolly, prevent the water from
entering into air intake lines of the
engine, rear axles and transmission
case. Check rear axle and trans -
mission case for entering water after
padding. If there is water, drain off it
and add specified quantity of gear
oil. The vehicle should not run at a
high speed after padding, brake
pedal should be depressed at
intervals to resume the braking
performance as soon as possible.
When running on icy or snowy road,
run at steady speed. Do not take
emergency braking and do not turn
the steering wheel fiercely to avoid
skidding danger. Keep long safety
distance from the foregoing vehicle.
When running in heavy rain, drive the
vehicle more carefully to avoid
decreasing the braking performance
of the brake because of moist. Do
not take emergency braking opera -
tion to avoid the danger of skidding .
2. Swerving
Swerving of the vehicle produces
centrifugal force which can be bigger
when the vehicle speed becomes
higher. The force can bring turning
over in the transverse direction in
serious condition. Therefore, in the
50 -100 meters position before
swerving, you should ring the horn,
turn on the turning lamp and reduce
on the freezing and muddy road or in
the weather of heavy rain, fog, wind,
sand and reduce the vehicle speed
to less than 10km/h, swerve the
OWNER
爷
S MANUAL for
HFC1061,HFC1063,HFC1083
series trucks
19
vehicle solely alongside the right
side of road. When swerving, turn the
steering wheel uniformly according to
the situation of road, the swerving
track should be transited smoothly ,
the turning motion should not be too
great or too small. Do not turn or
return the steering wheel suddenly.
Try your best to avoid taking braking
operation while turning the steering
wheel, especially emergency braking.
When steering, if found skidding of
the front wheels, put up the
accelerator pedal and turn the
steering wheel properly along the
skidding direction, and correct the
running direction after the skidding
stops.
3. Turning around
院
When turning the vehicle around by
180
益
, select the square, large -
scale crossing or flat broad which
have little traffic flux and turn around
the vehicle at a time along the
running direction. At the 50 -100
meters position in front of the turning
spot, reduce the vehicle speed, shift
into low gear and send out turning
around signal.
When turning around with running
forwards and backwards , send out a
turning around signal at first, reduce
the vehicle speed and run towards
the right side of road . When
approaching the preset spot for
turning around, observe the situation
of road, turn the steering wheel to the
left extreme position rapidly and
have the vehicle run to the left side
of road slowly. When approaching
the roadside, return the steering
wheel rapidly. After observing the
situation behind the vehicle , start
and turn around vehicle, turn the
steering wheel to the right extreme
position at the same time. When
approaching the roadside, return the
steering wheel rapidly and stop the
vehicle. If the turning
around
operation can not be done for once ,
repeat the operations above.
4. Backing
院
The operation of shifting into reverse
gear or shifting from reverse gear to
onward gear can be done after the
vehicle stopped completely. After
shifting into the reverse gear, the
