the locking function of lock arm on
the rear bracket, then lower the cab
down slowly. After the safety lock be
locked, fasten the locking mech -
anism.
Inspection and maintenance
1. Check periodically the rubber pad
assemblies which are used to
strengthen the front
尧
rear support, if
found damaged, it should be
replaced instantly.
2. Check periodically the locking
situation of the locking mechanism, if
found not work, it should be repaired
or replaced immediately.
3. If it is difficult to tilt up the cab and
put it down, the torsion rod cannot
work. Replace the torsion rod.
4. When repairing the chassis, before
removing the cab, disengage the
force of the torsion rod and operate
with the following steps.
荫
Disengage the locking state, and
tilt up the cab to the highest position.
荫
Remove the shaft pin connected
the rear support rod and the
baseboard support of the cab.
荫
Push the cab forward to some
angle until the bolt on the torsion rod
arm can be loosened.
荫
After the bolt removed, the torsion
rod cannot work. Now the cab can
be removed ( The torsion rod can not
be pulled out).
5. Before reverting the cab to the
original position, return the force of
14
OWNER
爷
S MANUAL for
HFC1061,HFC1063,HFC1083
series trucks
Note:
The mentioned above work
must be done by three persons
at least because two or three
persons cannot push the cab
forward after the force of the
torsion rod disengaged.
the torsion rod and operate with the
following steps:
荫
Put the tooth part of the spline
which is cut at the bottom on one end
of the torsion rod in alignment with "1"
position on the support axle tube and
the spline tube, and insert the torsion
rod into the support axle tube ( for the
rod which is pulled out).
荫
After mounting the cab with
support axle tube and the left
尧
right
bracket together to the frame, put the
"1" of hub splines on the torsion rod
in alignment with the spline tooth
which is cut at the bottom on the
other end of the torsion rod, cover
the hub splines on the torsion rod
and insert the spline axle tube into
the right bracket in the cab.
荫
Tilt the cab forward until the bolt
hole on the torsion rod arm aimed at
the screwed hole on the right bracket
in the cab, screw the bolt and tighten i.
荫
Put the cab down slowly, and
check whether the cab is on the
state of suspending in the horizontal
direction after dropped down. If it
works normally, lock the cab.
6. If finding the torsion rod not work,
referring to (4)(5) when replacing it.
Starting and running of the
vehicle
Starting of the vehicle
Starting of the engine
After making preparations for starting
engine, first, put the shift bar on the
neutral position, turn on the ignition
switch, then check horns
尧
instruments
on the instrument panel
尧
turning
lamps
尧
braking lamps
尧
the angle and
position of the rear view mirror.
1. Routine start
Turn the key to the START position ( As
shown on the right figure), the engine
can start. After starting, loosen the
accelerator pedal immediately and
keep the engine working in low speed.
Pressing
the
accelerator
pedal
15
