Fuse
Splice
Splice
Splice
Splice
Switch
(+)
(+)
(–)
Red (+)
Red (+)
Battery
Pump
VDC Pump
Controller
(–)
(–)
(+)
Black (–)
Black (–)
Pump
Leads
Battery
Leads
Wiring
Auto-Alignment
• Disconnect the power to the pump.
• Connect pump wiring to the “PUMP” leads of the controller.
Observe proper polarity as indicated on the controller.
• Connect controller “BATT” wires to the power
supply. Observe proper polarity as indicated on
the controller.
• Turn on power to the pump circuit.
• Allow water flow to purge air from the lines. System must be
completely purged.
• When air has been purged and a smooth flow is reached, close
each valve, one valve at a time. Gradually close the last valve.
• The control will auto-align itself to the pump in a few seconds.
The system is then ready to use.
City Water
Inlet
(optional)
Water
Tank
Check Valve
used with
Water Heater
Shower
Fixture
Sink
Faucet
Existing
Water Pump
Low-Point
Drain
Inlet
Strainer
VSD Smooth-Flow™
Controller
Water
Heater
(optional)
Plumbing
• Turn off power to the pump.
• Shut off water supply to pump.
• Open faucets and low-point drains to relieve pressure in lines.
• Disconnect existing hose connection from pump outlet (see Figure 1).
• Connect pump discharge hose line to either line port in the controller.
Make sure the snap-fit gate fittings on the controller
snap securely into place when attaching hose
lines (see Figure 2 as example).
• Connect water system hose line
to remaining line port of pump
controller (see Figure 2
as example).
Pump
Outlet
Existing
Hose Connection
Pump
Outlet
Existing
Hose Connection
Figure 1
Figure 2
