3
A s s e m b ling the base unit and connecting
to the telephone
1 ) Disconnect handset cord from telephone and connect to port
marked with the
0
icon at the bottom of base unit. Connect
one end of modular connector cord to handset port and the
other end to the bottom of base unit marked with icon
1
.
Connect the AC Power Adapter to the port marked with icon
2
at the bottom of base unit, and then to the power outlet.
Tu rn on power (see Figure 1).
2 )
Mount base unit by aligning the tabs extending from the
bottom of the base unit with the corresponding slots on the
stand. Tu rn clockwise until secure. The 3 cords should extend
f rom the back of the base unit. Align the center tab of the
headset stand with the port on either side of the base unit.
Slide the ends of the headset stand over until it locks into
place (see Figure 2).
3 )
Align the tab at the bottom of the battery with the notch on
the back of the remote unit. Push the battery flush against the
remote until it clicks into place. (see Figure 3).
4 )
Connect headset to bottom of remote unit. Insert remote unit
into base unit. Either side may be used. The battery charg e
indicator marked with icon
5
on base unit will light up.
This will be re f e rred to as the front of the base unit (see
F i g u re 4). Fully charge remote for 3 hours before using.
Figure 2
Figure 1
Figure 3
Figure 4
Ellipse manual final 5/26/99 9:55 AM Page 3