Master code
Is an extra (15
th
) access code for the supervisor. It can operate the system and it
also allows for the programming of the other user codes and to enter the user mode
(see section 4).
Factory default
master code is
1234
. The supervisor should change it after
installation.
Service code
Is an extra code, used by the installer to enter the programming mode. End users
are not usually told this code.
If an invalid access code is entered
more than four times in a given period of
time, it will trigger a Tamper alarm on the control panel.
3.1 Arming
On the keypad
- enter your user code or press the fast arming button
On the remote control
(RC-4x) – press the button
•
system will beep once and the exit delay countdown will start
•
ARMED indicator will flash during exit delay
•
you should leave the protected area within the duration of the
exit delay
If there are
4 beeps while arming
, the system is indicating an unusual situation
and the keypad will display the specific information:
ALARM and a zone number
– the zone is not ready (opened door etc.),
check the indicated item.
b
– some detectors are bypassed (done by supervisor, see part 4.5)
Note:
supervisor can program an automatic arming for a desired time (for
example, the house will be armed automatically at 21:00 if left disarmed).
Automatic disarming is also programmable. See part 4.4 for details.
*
Fast arming (without access code) can be disabled by the installer
**
The JA-60F battery powered wireless keypad will stop indications 10sec after the most recent key
entry.
Alarm system JA-63 „Profi“
- 5 -
MGK51504
Summary of Contents for Profi
Page 1: ...JA 63 Profi User manual...
