Device X
(
13.)
turn ON
* 81
turn OFF
* 80
Device Y
(
14.)
turn ON
* 91
turn OFF
* 90
The outputs may be used to unlock locks – opening a door via a short impulse).
In this case, enter the following:
an impulse to operate
(
13.)
is provided by pressing
* 8
an impulse to operate
(
14.)
is provided by pressing
* 9
Optionally, the system can be pre-programmed by a service company so that
the above operations require an access code (card).
9. Remote control – by phone, Internet
If the control panel is equipped with a suitable communicator
(
C.)
you can
control it remotely by mobile phone (directly by using the phone’s keypad or
by SMS). It can be also controlled via the Internet – after registration on
www.GSMLink.cz
For further details see also the communicator’s manual.
User configuration – access codes (cards)
The following description is intended for a system administrator, who knows
the control panel master code or possesses a master card which is authorized to
modify the system configuration.
All the settings can be performed via keying-in on a system keypad (or very
comfortably via a PC running Olink software). An unfinished sequence can be
cancelled by pressing the
#
key. A sequence is stored into control panel
memory only after the sequence has been completely entered.
Note: The Oasis JA-80 system has three modes: operating mode,
maintenance mode and service mode. Operating mode is for the day-to-day
use of the system by all authorized users, e.g. setting/unsetting
(arming/disarming). Maintenance mode is for the holder of the master code
(system administrator) to have limited programming of the system, e.g.
changing codes/cards, bypassing and is inaccessible to all other users. Service
mode is only for installers and is used to program and control all aspects of the
system.
Oasis user manual
9
MKE22102
