INSTALLATION:
hose to arch
– Screw hose inlet hand tight into end of boom arm. No sealant is required. Slide hose clamp
and rubber 2” x 1.5” hose adapter over barbed end of metal hose adapter. Leave at least
3/4” gap from end of rubber hose adapter to flange on metal hose adapter.** Tighten hose
clamp over rubber adapter to metal adapter interface. Thread 1 ½” x 25’ hose into rubber
hose adapter. Insert metal adapter into hose inlet, the adapter will be held into place by the
prongs on the spring lid of inlet. Next determine the length of the hose required for your
application and cut off excess that may not be needed.
22
Hose Inlet
Metal Hose
Adapter
Rubber Hose
Adapter 2” slip on
to 1.5” hose thread
Hose Clamp
1-3/4
– 2-3/4
1.5” Hose
REV 12-1-20
**Optional 6063-7W
small boom does not
contain metal
adaptor and
threaded hose inlet.
Summary of Contents for 75000-SWL Series
