Configuration
3 Configuration
In order to operate the CAN@net in your network, you must adjust the network
parameters of the device. These parameters are altered via a terminal program. If
you have started the configuration, the terminal program will lead you through
simple setting dialogs. Fig. 3-1 shows the sequence of the setting dialogs.
Network
configuration
DHCP
settings
IP address
Subnet mask
Gateway
address
Hardware
configuration
Baudrate
setting
Startup
delay
SAVE
Yes
Yes
No
No
DHCPactive
User
Password
Fig. 3-1 Sequence of the setting dialogs
When you have altered the parameters, the CAN@net must be restarted in order
to accept the new parameters.
During the configuration the CAN and the Ethernet LEDs are blinking green and
red. The CAN LED is a few moments longer blinking than the Ethernet LED. After
the CAN LED stopped blinking, the configuration is done.
Copyright IXXAT Automation GmbH
CAN@net Manual, Version 1.7
9
