21 (32)
6.4
Configuration of Bridge Modes (Local CAN, CAN-Eth-CAN)
In the CAN-Ethernet-CAN Bridge mode each device can be configured differently. But to build a Bridge
configuration all devices must be configured in one configuration file. The configuration has to be set
completely for all devices (Master, Slave 1 to 3) and then the complete configuration has to be
downloaded to each device. In the Local CAN Bridge mode only one device is connected and has to be
configured.
Exclusively one master device is allowed in the Bridge mode.
Fig. 9
CAN-Gateway Configurator CAN@net NT 420
For more information about the setting possibilities (e.g. general settings, baud rate, MQTT) and
descriptions of the further configuration possibilities (e.g. J1939 Mapping, cyclic transmission)
see User Manual
CAN-Gateway Configurator
on
.
►
Make sure, that the Master device is connected to the network (see
) and to the CAN-Gateway Configurator (see
Connecting the Device in the CAN-
►
In drop-down list (
1
) select the desired bridge operational mode.
CAN@net NT User Manual
4.01.0332.20000 1.7 en-US
