12 (32)
►
Make sure that the cross-sectional area of the cable is larger than or equal to 0.14 mm
2
resp.
25 AWG.
►
To remove the connector, use screwdriver or similar tool.
►
Connect the CAN cables.
►
Connect the power supply.
►
Plug the connector into the housing.
The shield of the CAN connector is connected to the device ground and the PE on the back of the
device (DIN rail) via a 1 MΩ resistor and a 10 nF capacitor. To achieve highest interference
immunity, ground the shield of the CAN cable.
5.2.1
Power Connector
Pin Allocation
Pin no.
Signal
1
V+ (+9 V to +36 V DC)
2
V-
3
—
4
—
5.2.2
CAN and CAN FD Connectors
Pin Allocation of Terminal Adapters
Pin no.
Signal
1
CAN high
2
CAN low
3
CAN GND
4
Shield
If a D-Sub 9 connector is used for the terminal adapters, observe the pin allocation of the D-Sub
9 connector.
Pin Allocation of D-Sub 9 Connector (CAN@net NT 100 and Adapter)
Pin no.
Signal
1
—
2
CAN low
3
CAN GND
4
—
5
Shield
6
—
7
CAN high
8
—
9
—
CAN@net NT User Manual
4.01.0332.20000 1.7 en-US
