Digital Controller
- The digital controller is located
inside the the low profile solar panel stand. The digital
controller operates and monitors the SolarBee. The
digital controller is programmed with application specific
run schedule, fallback rpm, and battery charge settings.
The SolarBee's Design and Application Engineering
groups are constantly reviewing the program to optimize
operation. The digital controller can be updated with
a new program (firmware) using a SD (Secure Digital)
Card, similar to that of a digital camera's memory stick.
All solar energy collection and motor operation are
managed by the digital controller. This component
has two primary functions: (1) To direct and divide the
power being collected by the PV module(s) between the
brushless motor and battery. (2) To serve as the main
control center that operates the brushless motor.
There are 3 PV module connections located on the
front face of the digital controller. If the onshore power
accessory was purchase, a connection will be located
on the right side face. The onshore connection is
used only in applications where onshore grid power is
desired.
The left side face of the digital controller contains the
brushless motor connection, battery connection, and
On/Off switch. The On/Off switch activates power to the
motor. When the switch is turned to the Off position,
the motor will not operate. The charging function of the
controller will continue to charge the battery even when
the switch is turned off.
SCADA outputs offering machine operation parameters
reside within the digital controller. Please contact
SolarBee if you are interested in receiving these
parameters.
Front Face Of Digital Controller
Left Side Face Of Digital Controller
©2022 IXOM Watercare Inc. | www.ixomwatercare.com | 866 - 437 - 8076 | [email protected]
Features
Features
SB PW Series Mixers
10253_20220110
O&M_SB5000PW_10272_20220119 - 7