Distribution Dish Level Setting
The machine distributor dish depth in the water is a
key factor in maintaining the near-laminar flow of water
coming off the machine.
The distribution dish level setting is measured from the
top lip of the dish up to the water surface. For the Large
Frame machine, set the depth level according to the
following table:
Model
Depth - Inch
Depth - cm
2500
3/4 - 1
2.0 - 2.5
5000
1 - 1 1/2
2.5 - 3.8
7500
2.0 - 2 1/2
5.1 - 6.4
10000
2.0 - 2 1/2
5.1 - 6.4
Distribution Dish Level Adjustment
TOOLS RECOMMENDED:
Tape Measure
STEP 1:
If machine is not on, turn the On/Off switch to
the On position.
STEP 2:
Observe if the dish level is too deep or not
deep enough at the three locations where each float arm
extends out from the machine. This can be done using
a tape measure, by approximating the height of a nickel,
or locating the notch on each chain bracket for machines
having a hose. If using the notch on each chain bracket,
the water level should be even with the appropriate notch
(see picture).
STEP 3:
Set the dish to the correct level in each of
the three locations. To raise the dish level, rotate the
turnbuckle around (clockwise) so that it is expanding.
To lower the dish level, rotate the turnbuckle around
(counter-clockwise) so that it is compressing.
STEP 4:
Double check dish level at all three locations
and fine tune as necessary.
Distance Between Distributor
Dish And Water Level
Dish Depths For Different Models of machines
10000
5000
2500
WATER LEVEL NOTCH SETTING FOR:
Water Level Even With Notch On Chain Bracket
Turnbuckle Handle
Chain Bracket
Notch
Dish Level
Water Level
Refer to table
on the left.
7500
©2022 IXOM Watercare Inc. | www.ixomwatercare.com | 866 - 437 - 8076 | [email protected]
Maintenance
Large Frame Dish Levels
SB / GF Series Large Frame Mixers
10422_20220110
O&M_SB5000PW_10272_20220119 - 35
