EN
(5) Feed the wire through the drive roller
and into the outlet guide tube of the wire
feeder.
(6) Lock down the top pressure roller and
apply a medium amount of pressure using
the tension adjustment knob.
(4) Snip the wire carefully, be sure to hold
the wire to prevent the spool uncoiling.
Carefully feed the wire into the inlet guide
tube of the wire feed unit.
(3) Fit the wire spool onto the spool holder
fitting the locating pin into the location hole
on the spool. Replace the spool retaining
nut tightly.
(7) Check that the wire passes through the
center of the outlet guide tube without touching
the sides. Loosen the locking screw and then
loosen the outlet guide tube retaining nut too
make adjustment if required. Carefully retighten
the locking nut and screw to hold the new
position.
34
Summary of Contents for 800MLTG2400PFC
Page 131: ...www iweld hu...
