Iwatsu Omega-Phone ADIX APS, Owner'S Manual

Page: 45 / 244

ADIX APS GENERAL DESCRIPTION - 31
IX-044
See description under Station Interface Cards.
IX-400
The IX-400 Caller ID trunk module is connected to the IX-044 card. It
interfaces the ADIX-S and ADIX-M to eight Caller ID loop start circuits.
Ports: 4 ports/card
Additional Power: None
Features: 600/900 Ohm impedance selection, Long/Short distance selection
IX-4EMTK
The IX-4EMTK card interfaces the ADIX to four circuits for four wire E&M
tie lines for system to system connection. Either Type 1 or Type 2 E&M can
be selected as required by the customer.
Ports: 4 ports/card
Additional Power: 48 VDC (IX-DCDCA, IX-DCDCB or IX-DCDCM)
Features: Type 1/Type 2 selection
FIC Code: Type 1: TL31M
Type 2: TL 32M
IX-4DITK
The IX-4DITK card interfaces the ADIX to four Direct Inward Dialing
(DID) circuits. The incoming DID numbers can be translated to any station
number through database programming. Communication modes of the DID
circuits can also be selected. An additional DTMF receiver (IX-4RCVS) is
required for the DTMF address signaling.
Ports: 4 ports/card
Additional Power: -48 VDC (IX-DCDCA, IX-DCDCB or IX-DCDCM)
Other Requirements: IX-4RCVS for DTMF dialing
Features: Mode Selection - Attendant, immediate, wink, delayed wink.
IX-T1DTI AND IX-DTI-T
The IX-T1DTI card or IX-DTI-T interfaces the ADIX to one T1 span and
has the ability to support the following configurations: loop start trunk,
ground start trunk, E&M trunk, E&M tie, DID trunk, ANI trunk, DNIS trunk,
single line telephone, off-premise telephone. In addition, the card may be
configured to provide the following clocking options: Master, Slave-
Primary, Slave-Backup or Slave-Private.
Ports: 8, 16, 24 ports/card
Features: loop, ground, E&M trunk, E&M tie, DID, ANI, DNIS, OPX, SLT
Other Requirements: IX-PLLU, IX-T1RCV (optional), IX-8ERCV (optional)
Framing: SF or ESF with AMI or B8ZS