- 41 -
[3] Install the rear casing cover (159) and rear casing (158)
onto the bracket (330). Next, insert the gasket (400.2)
to be fixed on the front casing side.
* Previously fit the bolt M12
◊
100 provided for the
bracket into it fully to its depth. If this bolt is not used,
the magnetic capsule is abruptly attracted by the virtue
of magnet and it sometimes causes ceramic and
plastic the part to be broken.
In order to prevent this failure, it is necessary to
put magnet capsule into rear casing gradually with
using this M12
◊
100.
[4] Direct the bracket precisely vertical to the front casing
on the base and install it along the stud bolt (902).
Loosen the attached bolts (M12
◊
100) alternately to
pull the bracket slowly backward, to install it finally
onto the front casing.
* Note that the magnetic force of the magnet capsule is
very strong.
* When assembling, be careful not to let your fingers or
hand get caught.
[5] Fix the bracket firmly with the front casing by
tightening both the hex bolt (901.8) and hex nuts (920).
Tighten these bolts diagonally to apply an even torque.
Fastening torque: 58.8N·m
* At regular intervals, increase the fastening of the parts
which fix the bracket to the front casing. Fasten them
only after the hex head bolt (901.3) is loosened.
[6] Install the drain plate and fasten the bolts.
