IVT PKS 1000, Installer'S Manual, Page: 32 / 36

Factory values
6 720 642 838 (2010/03) 32
10 Factory values
Access level 0 = customer, 1 = installer
Room temperature F value Level
General No settings for cooling
Circuit 1 Heating No settings for cooling
Circuit 1 Cooling Primary cooling circuit Allow cooling in winter operation No 1
Outdoor temperature limit for cooling 21 °C 1
Room sensor None 1
Room temperature 20 °C 1
Room temperature change in cooling
mode 2,0K 1
Cooling/heating change over delay 8h 1
Room temperature hysteresis 1,0K 1
Acknowledge anti-freeze sensor T32 No 1
Anti-freeze limit T32 3 °C 1
Flow sensor E31.T31 1
Dew point sensor installed No 1
Minimum set point value T1 at cooling
- With dew point sensor
- Without dew point sensor
10 °C
17 °C 1
1
Regulator settings
- P constant
- I constant
- D constant
- Minimum PID signal
- Maximum PID signal
- Mixing valve running time
1.0
300.0
0.0
0%
100%
300s
1
1
1
1
1
1
Circuit 2, 3... Mixing valve mode Off 1
Heat curve
(mixing valve operating mode is Heat-
ing or Heating/Cooling) Type of heating system Underfloor 1
Flow temperature at minimum outdoor
temperature 35 °C 1
Parallel offset 0.0K 1
Highest permitted flow temperature T1 40 °C 1
Lowest permitted flow temperature T1 10 °C 1
Cooling
(mixing valve operating mode is Heat-
ing/Cooling or Cooling) Allow cooling in winter operation No 1
Outdoor temperature limit for cooling 21,0 °C 1
Room temperature change in cooling
mode 2,0K 1
Cooling/heating change over delay 8h 1
Room temperature hysteresis 1,0K 1
Dew point sensor installed No 1
Minimum set point value T1 at cooling 17.0 °C 1
Tab. 41 Room temperature, factory settings cooling
External input prim. cooling circuit Block cooling No 1
External input circuit 2, 3... Block cooling No 1
Tab. 42 External input, factory settings cooling
Outputs Manual operation time 0min 1
Circulation pumps Collector circuit pump G3 active in cooling No 1
Tab. 43 Installer, factory settings cooling