20
5201335 REV A
IQ POWER BPS-C POWER SUPPLY
6. MAINTENANCE
NOTE
– Only qualified service personnel are to perform maintenance tasks.
CAUTION – Electrical Shock Hazard
Turn off power supply before cleaning bar or performing any maintenance
on the system.
ATTENTION – Risque De Choc Électrique
Coupez l’alimentation électrique avant de nettoyer la barre ou d’effectuer
un entretien sur le système.
WARNING – Fire Hazard
Do not turn on power supply with any trace of alcohol or mineral spirits
on the equipment.
AVERTISSEMENT – Risque d’incendie
Ne pas installer ou d’utiliser le l’alimentation électrique à distance à
proximité de liquides ou de solvants inflammables.
Occasionally check to make certain that all ground and electrical connections are
clean and secure. Periodically inspect all cables to ensure that there are no cuts,
abrasions, or damage that can lead to operator shock or equipment damage.
The accumulation of contamination on the ionization emitter points and static
bar surfaces will reduce neutralizing efficiency of the Conveyostat, therefore it is
recommended that maintenance of the system be performed when the Clean Bar
indicator on the display illuminates. Dirty environments may require more frequent
cleaning. Maintenance should be performed by qualified service personnel only.
Cleaning the Static Bars
A clean brush with nylon bristles should be used to keep the ionization emitter
points of the static bar clean. Periodic use of the brush will prevent deposits from
accumulating on the points. The emitter points must remain sharp for optimum
operation.
NOTE
– Do not scrape points with any hard or sharp object that may
damage points.
1. Turn off power supply.
2. Remove dirt particles deposited on the static bars with a dry, stiff nylon bristle
brush.
3. Blow off the static bars with clean, dry compressed air.
