ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
08172 Sant Cugat del Vallés · Barcelona (Spain)
Phone: +34935839543 · [email protected] · www.ek.plus
10
USER MANUAL
CCA
6.1. Numbering user cards
To keep a correct control of the identifier associated with each card, it is important to know that:
•
The first card discharged is the 000.
•
The second will be 001, the third will be 002 and so on until the last (thousand) that will be the
999.
•
If the third card is deleted, a hole (bubble) is created between 001 and 003.
•
When registering a new card with the master cards, this bubble will be filled (the new card will
be 002).
•
With the remote control, you can force a card to have a specific identifier, leaving bubbles if
desired.
•
There cannot be two user cards with the same identifier.
It is recommended to register the identifier by relating it to the serial number of the card and to the user
of the card. It is not recommended to write down the identifier on the card itself. Should it be lost, the
identifier to be removed from the controller will not be known.
Identifier
Serial Number of the user card
Person / Department / Apartment
0
0093119565
Mr. Juan Pérez
1
0093119566
Ms. Marta López
…
…
…
999
0093117684
Ms. Teresa Monte
6.2. Programming via keyboard (remote control)
The supplied remote control allows the programming of the controller. To do this, aim it to the IR sensor
and press the indicated commands.
6.2.1 Signals when programming the CCA
When you turn on the CCA the LED will change from green to red and beep.
•
Press on the controller: red LED will flash, after 5 seconds it returns to normal state and will
stay in fixed red.
•
Press 1 2 3 4 5 6: LED goes
green, whistles once and will flash red. After 35 seconds it will
return to normal and stay in fixed red.
•
Press Incorrect code: It will emit three beeps and the LED will remain red, it will not enter
programming mode
.
