ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
08172 Sant Cugat del Vallés · Barcelona (Spain)
Phone: +34935839543 · [email protected] · www.ek.plus
15
USER MANUAL
CCA
6.3. Programming via master cards
By using the master cards it is possible to subscribe / unsubscribe user cards, without need to use the
remote control.
This method does not allow to delete a user card that has been lost, even knowing its identifier.
6.3.1. Registering master cards
The master cards need also to be paired to the system. Should a second pair of master cards is
registered, the first will be unregistered. The master cards, cannot be programmed via keyboard.
Step 1
Power off the controller
Step 2
Make a short circuit between GND and OPEN.
Otherwise, should a push button be connected
(for opening purposes), keep it pressed
Step 3
Power on the system again
Two sounds will be heard and
the LED will change its colour
Step 4
Present the two cards on the card reader. The
first will be coded as
“MASTER ADD”
(For
subscribing). The second, will be
“MASTER
DELTE”
(For unsubscribing).
After each card presentation, a
single sound will be heard.
After presenting the second
card, the system will enter in
stand-by mode.
If any card is presented within
10 seconds, the system will
enter in stand-by mode.
Step 5
Remove the bridge
Master cards cannot be programmed by keyboard.
6.3.2. Management of user cards using master cards
To add user cards, perform this process on the reader:
Step 1
Sweep MASTER ADD card
Step 2
Sweep the user card
More user cards may be swept (A
sound will be heard)
Step 3
Sweep MASTER ADD card
