ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
08172 Sant Cugat del Vallés · Barcelona (Spain)
Phone: +34935839543 · [email protected] · www.ek.plus
11
USER MANUAL
CCA
6.2.2. Programming mode (via remote control)
In this mode it is possible to carry out the programming using the remote control by entering different
commands.
•
To enter this mode, press:
Enter in the programming mode
< Master code >
(Default master code
123456)
Exit the programming mode
•
To change the master code
Step 1
Enter in the programming
mode
< Master code >
Step 2
Insert the new master code.
It's a 6-digit code
0 < New master code >
< New master code >
Step 3
Exit the programming mode
If you change the master code, remember it. Otherwise it will be necessary to make a factory default
reset.
It must have 6 digits.
6.2.3. User management (via remote control)
Each user card is registered with an identifier that matches its position within the system. The controller
can assign auto-incremented identifiers. You can also assign a specific identifier.
•
Subscribing:
To add user cards at a position given by the system:
Step 1
Enter in the programming mode
< Master code >
Step 2
Pass the card through the reader and
press
Repeat this step if several cards
need to be registered
1 < Sweep card >
Step 3
Exit the programming mode
Remember that in the case there are empty positions not assigned to a card (Bubbles), this
process will assign to the card registered the first available position/identifier. A bubble will
appear when a specific card (Not the last one) has been removed.
