7
Step 1
Power off the controller
Step 2
Make a short circuit between GND and OPEN.
Otherwise, should a push button be connected (for opening
purposes), keep it pressed.
Step 3
Power on the system again
Two sounds will be heard
and the LED will change its
colour
Present the two cards on the card reader. The first will be
coded as “MASTER ADD” (For subscribing). The second,
will be “MASTER DELTE” (For unsubscribing).
After each card
presentation, a single
sound will be heard. After
presenting the second card,
the system will enter in
stand-by mode.
If any card is presented
within 10 seconds, the
system will enter in stand-
by mode.
Step 4
Remove the bridge
6.3.2. Management of user cards using master cards
Subscribing:
Step 1
Sweep MASTER ADD card
Step 2
Sweep the user card
More user cards may be swept (A sound will
be heard)
Step 3
Sweep MASTER ADD card
Unsubscribing:
Step 1
Sweep MASTER DELTE card
Step 2
Sweep the user card
More user cards may be swept (A sound will
be heard)
Step 3
Sweep MASTER DELETE card
6.4. Restore to factory default values
The following process restores the original default factory values. Registered user cards, are NOT lost. Registered
master cards, yes. Other values are set back to factory default.
Step 1
Power off the controller
Step 2
Make a short circuit between GND and OPEN.
Otherwise, should a push button be connected (for opening
purposes), keep it pressed.
Step 3
Power on the system again
Two sounds will be heard
and the LED will change its
colour
Step 4
Keep the short circuit for at least 10 seconds.
A sound will be Heard and
will enter in stand-by mode.
(Red LED)
