Itronix X-C 6250 Pro, User Manual

Page: 130 / 173

130
X-C 6250 Pro User’s Manual
79-0003-003 22 October 1999
WARNING! Boot sector 0 has changed
The boot sector of the hard drive has been modified. This message also
may be displayed when booting from drive C after booting from another
device. Pressing
F1
will allow the system to continue to boot. If this
problem persists, contact your organization’s help desk.
-WARNING: CMOS checksum invalid - run SCU
-WARNING: CMOS failure - run SCU
Run the System Configuration Utility (SCU) to set the system
configuration. If the problem persists, contact your organization’s help
desk. (See Section 5, “Customizing Settings,” for more information
about the SCU.)
-WARNING: Floppy controller failed
-WARNING: Floppy disk track 0 failed
Restart the computer by pressing both mouse buttons for at least ten
seconds and then releasing the buttons. If the problem persists, contact
your organization’s help desk.
WARNING: F loppy information invalid - run SCU
Run the System Configuration Utility (SCU) to set the system
configuration. If the problem persists, contact your organization’s help
desk. (See Section 5, “Customizing Settings,” for more information
about the SCU.)
-WARNING: Keyboard controller failure
-WARNING: Keyboard failure
Reboot the computer by pressing
CTRL+ALT+DEL
. If the problem
persists, the keyboard is not usable; contact your organization’s help
desk.
-WARNING: No bootable floppy drive 0 installed
-WARNING: No interrupts from timer 0
Restart the computer by pressing both mouse buttons for at least ten
seconds and then releasing the buttons. If the problem persists, contact
your organization’s help desk.