IFH-1710 Red/Infrared LED Beacon
DOC-1710-MNL Rev20.doc
(10/7/2019)
Copyright 2009-2019 ITL, LLC Page 15 of
22
Setup and Operation
All setup functions are performed using the 6-
position DIP switch, SW2, on the controller
board. SW2 setup functions are described in the
table below. Six indicator LEDs show the status
of the LED beacon and GPS, as well as the
operating mode. LED Indicator functions are
shown in the table below.
Pressing the TEST button momentarily will cause
the unit to enter night mode operation for 10
flash cycles. Holding the TEST button
depressed for 3 or more flash cycles will cause
an alarm to be generated for test purposes.
SW2
DESCRIPTION
1
FLASH RATE:
ON - 30FPM
OFF - 20FPM
2
DUTY CYCLE:
ON – 67%(at 20FPM)
58%(at 30FPM)
OFF - 50%
3
INHIBIT ENABLE: ON – Flash Inhibit Input Enabled
OFF – Flash Inhibit Input Disabled
4
GPS ALARM:
ON – GPS Alarm Enabled
OFF – GPS Alarm Disabled
5
FTB-360i
ON – FTB-360i Compatibility Mode
OFF– Standard Operation
6
L350-864-G
ON – L350-864-G Mode
OFF – Standard Operation
7
Unused OFF – Must Remain OFF
8
Unused OFF – Must Remain OFF
LEDs
DESCRIPTION
BCN
GRN – Beacon Confirm
RED – Beacon Alarm
MODE
GRN, FLASHING – Indicates Night Mode
GRN, OFF – Indicates Day Mode
RED – Mode Alarm (Photodiode Alarm)
GRN & RED FLASHING – Flash Inhibit Active
GPS
GRN, SOLID – GPS Fix
GRN, FLASHING – GPS Acquiring
RED – GPS Alarm
Figure 9: ITL-0720-CTL Controller Board
Figure 10: IFH-1710 Controller Board DIP Switch Settings
Figure 11: IFH-1710 Controller Board LED Indicators
